迪威網(wǎng)友57241b
發(fā)布時(shí)間：2024/1/17 8:48:00
I got the idea to build a Hovercraft last year when I read an article about Hovercrafts. From then I studied the topic and wanted to build one for myself.
This is my third prototype because the other ones had some issues.
They rotated around their own axis -> I could not control them
They could not carry enough weight
Small stones destroyed the propeller of the lifting motor -> I glued
two bicycle tubes under the base.
For the design I used Autodesk Inventor 2013 and my printer was the MakerBot Replicator. It took around 3-4 days to print the third Hovercraft.
The base is not printed because it would take way too long. And Styrofoam has the advantage that it swims when the engines fail. I also did not print the bicycle tubes because they have to be flexible and they must be one piece so that no air flows out to the sides.
The Hoveraft is lifted by two moto and it has one thrust motor. The power for the moto comes from three 2800 mAh Lipo batteries.
My pla with the Hovercraft are to develop a cheap mobile research station for example for the arctic. The advantages are that it has no CO2 emissio and you can control it from another place like a drone.
Just ask if you have a question!
Here are two links to articles that have been published:
Here is the link for the video:
This is my third prototype because the other ones had some issues.
They rotated around their own axis -> I could not control them
They could not carry enough weight
Small stones destroyed the propeller of the lifting motor -> I glued
two bicycle tubes under the base.
For the design I used Autodesk Inventor 2013 and my printer was the MakerBot Replicator. It took around 3-4 days to print the third Hovercraft.
The base is not printed because it would take way too long. And Styrofoam has the advantage that it swims when the engines fail. I also did not print the bicycle tubes because they have to be flexible and they must be one piece so that no air flows out to the sides.
The Hoveraft is lifted by two moto and it has one thrust motor. The power for the moto comes from three 2800 mAh Lipo batteries.
My pla with the Hovercraft are to develop a cheap mobile research station for example for the arctic. The advantages are that it has no CO2 emissio and you can control it from another place like a drone.
Just ask if you have a question!
Here are two links to articles that have been published:
Here is the link for the video:
|
共個(gè)文件
壓縮包大?。?MB
|
||
|---|---|---|
微信小程序
微信掃碼打開此模型
迪威模型
微信掃碼支付